1. No Bluetooth device found
: To use the Bluetooth function, you must turn on the Bluetooth switch correctly.
1. Bluetooth disabled
: To use the Bluetooth transmission function, you must enable the Bluetooth function on your tablet.
1. On the standby page, slide the top curtain above the screen with your fingers.
2. Set [Bluetooth] to green.
. Bluetooth enabled
: After Bluetooth is enabled, the receiver's mobile phone's Bluetooth must be enabled and visible for retrieval.
To use the Bluetooth function to send files to the receiver, the receiver mobile phone (here in GT-N7100 for example) needs to enable the Bluetooth visible mode, the operation is as follows:
1. Click application on the standby page ].
2. Click set ].
3. Slide the slide block on the right of Bluetooth to the right. When it becomes Green, the table is enabled.
4. Click Bluetooth ].
5. Hook the device to enable the Bluetooth visible mode.
6. Click menu in the lower left corner and select visible timeout ].
7. Select the Bluetooth visible time as needed.
Tip: The distance between two Bluetooth devices is within 10 meters.
2. You can find the Bluetooth device but the pairing is unsuccessful.
: The two devices must be paired with each other to verify each other.
After searching, click "receive device". A Bluetooth pairing request is displayed. Click "OK" for both the sender and receiver devices ].
3. The file is successfully paired but cannot be sent
: The size of the file to be sent is too large, and the recipient must have enough memory.
Check the remaining memory capacity of the recipient's mobile phone. If the sent file is too large and the recipient's memory is insufficient, the file cannot be normally sent to the recipient. The GT-N7100 memory is viewed in [application]-[Settings]-[storage ].