Solution to the trouble caused by the loosening of computer memory strips

Failure phenomenon:

Phenomenon 1: After the boot, the monitor is dark, the chassis issued "beep-, beep-" long sound.

Phenomenon 2: After the boot, the monitor interface stays in the boot screen (can not enter the system desktop), and constantly restart.

Phenomenon 3: After the boot, the monitor is dark (the monitor is good), the chassis in addition to the fan rotation there is no other sound.

Failure reason: Memory loosening is usually due to the careless forced collision of chassis or indoor damp and so on, is a very common computer fault. Workaround:

1, the main power off the host (this step can not be less, otherwise very easy to damage memory).

2, with a Phillips screwdriver to open the chassis, the chassis fixed motherboard side flat on the ground, find memory location, hands first touch the chassis metal shell or metal pipe (put off the static electricity on the hands), with both hands and thumbs press the two ends of the memory, slightly hard sway around.

3, open the main engine power, to see whether the computer can start normally.

4, if not, turn off the total power again, the memory of the slots on both sides of the white card gently down, so that the memory bar pop-up slots.

5, the hands of the memory strip at both ends, the slot and card position, at one end of the first force, hear "Ka-" a sound, and then to the other end of the force until again appear "Ka-" a sound.

6, open the main engine power, to see whether the computer can start normally.

7, if it is still old phenomenon, you have to change the memory slot (general memory slot has two to three), and then repeat 4, 5, 63 steps.

8, if the above processing or not, that may be the reason for the memory itself, should consider replacing a new memory (to the merchant where the replacement is best to take up the memory strip, in order to buy the model matching memory).