Solve the problem that pxe + ks cannot be guided when the disk is larger than 2 TB. pxe2tb

Solve the problem that pxe + ks cannot be guided when the disk is larger than 2 TB. pxe2tb

Previously, the company's servers all had a GB ssd disk, and the system was deployed on the ssd. Later, some servers replaced ssd with 3TBsata disks, and the system could not be booted when the system was installed. As shown in:

After the analysis of the company's high personnel (Lang), it was because the centos boot system could not find the boot path where the disk was larger than 2 TB.
Solution:
Add the/boot partition to the system disk partition by adding the following command to the ks file:

Part/boot -- fstype ext4 -- size = 1024 -- ondrive = sda part swap -- size = 2048 -- ondrive = sda part/-- fstype ext4 -- size = 1 -- grow -- ondrive = sda

After the system is re-installed, the problem is solved.

Copyright Disclaimer: This article is an original article by the blogger and cannot be reproduced without the permission of the blogger.