Solve the problem when the computer's optical drive is out of position

Failure problem: Press the optical drive out of the warehouse key, heard inside there is a sound, feel out of the warehouse action, but the tray does not come out, even from the optical drive of the emergency out of the hole can not open the optical drive. How should this situation be handled?

Troubleshooting: The reasons for this situation are as follows:

(1) Out of the warehouse motor itself has a fault (generally is the use of the long time the optical drive), out of the warehouse motor due to wear, torque reduction, only to change the motor to solve;

(2) The use of optical drive, not by the optical drive panel in and out of the key, but with the hand to dodge disk, due to push the angle deviation, resulting in the optical drive parts deformation, card dead, then only to open the optical drive, will be stuck part of the correction just line;

(3) Some optical drive spindle motor on the tray (there is a strong magnet in the middle) and the upper pressure plate components to absorb more closely will also lead to not out of the warehouse. At this time we can be in the upper pressure plate assembly of the Contie film affixed with two layers of paper or adhesive tape, to reduce the spindle motor on the tray and the upper pressure plate assembly between the suction force can solve the problem;

(4) Some of the high-speed optical drive with plastic movement, the front side of the stent is prone to rupture, resulting in the pallet is stuck, then only the optical drive apart, the fault is glued to the adhesive, in addition, the use of plastic to properly strengthen the fracture is more solid.