Switch command 3-Huawei

41. Configure the default route:
Switch (enable) set ip route default gateway
42. assign a VLANID to a Route Processor. You can use the following command in interface mode:
Router (config) # interface number
Router (config-if) # mls rp vlan-id-num
43. Enable MLSP on the Route Processor:
Router (config) # mls rp ip
44. to place an external Route Processor interface and switch in the same VTP domain:
Router (config) # interface number
Router (config-if) # mls rp vtp-domain-name
45. view the information of the specified VTP domain:
Router # show mls rp vtp-domain vtp domain name
46. To confirm the management interface on the RSM or vro, enter the following command in interface mode:
Router (config-if) # mls rp management-interface
47. Check the configuration of the MLS-RP:
Router # show mls rp
48. Check the MLS configuration on a specific interface:
Router # show mls rp interface number
49. To set the stream mask on the MLS-SE and do not want to set the access list on any Route Processor interface:
Set mls flow [destination | destination-source | full]
50. To make the MLS compatible with the input access list, you can use the following commands in global mode:
Router (config) # mls rp ip input-acl

51. When a switch's layer 3rd switch fails, you can enter the following command in the switch's privileged mode:
Switch (enable) set mls enable
52. To change the value of the aging time, enter the following command in privileged mode:
Switch (enable) set mls agingtime
53. Set quick aging:
Switch (enable) set mls agingtime fast fastagingtime pkt_threshold
54. Determine which MLS-RP and MLS-SE are involved in the MLS, first display the contents in the switch reference list and then confirm:
Switch (enable) show mls include
55. Display MLS cache records:
Switch (enable) show mls entry
56. Run the show in arp command to display the content in the ARP cache.
57. to configure the vro as a member of the HSRP backup group, run the following command in Interface Configuration Mode:
Router (config-if) # standby group-number ip address-address
58. In the interface configuration mode, to allow a vro to resume its forwarding role:
Router (config-if) # standy group-number preempt
59. The access time and retention time parameters are configurable:
Router (config-if) # standy group-number timers hellotime holdtime
60. Configure HSRP tracking:
Router (config-if) # standy group-number track type-number interface-priority