Tengda Tenda Router E882 How to set up a wireless WAN? E882 Wireless Network Configuration tutorial

attention. It is important to know the Safe Mode, channel, encryption rule, and key of the superior WiFi signal before setting wisp. )

The first step: Configure the computer's IP address

1. Find "My Network Neighborhood " on the computer and then right-click and click " Properties " as shown in the following figure

2. Go to the network and then right-click " Local Area Connection " and select " Properties "

3. Here we look at the Internet Protocol (TCP/IP)double-click it to enter

4. Here we set IP to " automatically obtain IP address ", " automatically obtain DNS server address ", OK now the computer set up, into a step.

Step Two: Configure the router's Internet access mode to DHCP

1. Now open the browser in the Address bar to enter 192.168.0.1 If you do not set the router password we can enter Admin (username password is admin) click " OK "

2. After entering the router, we find " Advanced Settings " and click on it.

3. On the right, we find the " Internet settings " found inside the " Dynamic Acquisition ", click OK

Step three: Scan for WiFi signals that require relaying

1. Now we turn on "Wireless Settings"-"Wireless Encryption" , set the steps as shown:

2. Now we're going to test the signal on the wireless scan.

Step Fourth: see if relaying succeeds

Finally, let's see if we can get on the Internet. If the Wan port connection status displays "Connected", the relay is proven successful.

All right, we have finished the configuration, but to note that some of the process we do not understand but must be set to be able to, such as setting the wireless password to disable WPS, in our sense that this should be enabled, but enable you can not set the password.