The Phantom by the upgrade process abnormal power change brick how to restore

TFTP upgrade Raiders (only for the Phantom of the Family router speed version)

Preparation: To prepare a network cable, one end of the router in the middle of the network port (LAN port), the other end of the computer network port. Shut down your computer's Windows Firewall temporarily or it will cause the TFTP upgrade to be unsuccessful! OK, let's start the computer setup.

First, enter the computer to set the network card fixed IP, such as figure one operation, into the "Control Panel"-> Network and internet-> Network and Sharing Center "local connection."

Click "Properties" in Figure II, select Internet Protocol version 4 (TCP/IPV4), click "Properties" and go to the Set computer fixed IP interface, as shown in Figure three.

Second, the computer static IP settings, according to figure three set fixed IP, click "OK" after the setting off.

Three, TFTP tool preparation

1. Cooy the Tftp32.exe tool and firmware (see attachment) to the same folder on the computer and change the firmware name to "Meizu_r18.bin" as shown in Figure four;

2. Open the "Tftp32.exe" application.

Four, the router to power up and upgrade

1. The router and IP for the 10.10.10.3 computer through the network cable Connection;

2. Long hold down the router's WPS key and give the router power;

3. Long press about 4-7 seconds (long time too long or too short will cause the upgrade to fail, if the TFTP service does not show progress bar, please try again, make sure long time in 4-7 seconds.) ), loosen the WPS key at this time;

4. The router automatically upgrades, the TFTP tool appears the following progress bar, as shown in Figure five, the firmware is in the upgrade.

Wait for the upgrade to complete (do not power off and disconnect the network cable during the upgrade process)

1. In the process of upgrading the router led always bright red light;

2. After the completion of the upgrade, the router automatically restarts the blue LED will start flashing;

3. Wait for the restart to complete, after the reboot LED lights become red illuminated steady;

4. After the upgrade is complete, please search the Phantom router name "Meizu-xxxx" with WiFi, and reset your router settings.

Update some of your small partners what you might encounter when upgrading your firmware unsuccessfully!!!

1, the best anti-virus software to turn off, sometimes Tftp32.exe program may be the anti-virus software manslaughter;

2, if it is Win7 or above the system, tools and firmware is best not placed in the C disk, to prevent the UAC and other firewalls banned;

3, please ensure that the computer network card is set to 10.10.10.3 address, before the user mistakenly will be broadband dial-up network labeled as a network card to set up;

4, after the release of the button time can not be too late or too early, too late or too early will lead to TFTP no response, upgrade unsuccessful.

At this point, your router is full of blood and resurrection.