TP-LINK wireless network card connection hidden wireless signal tutorial

This article introduces the front-end wireless router (or wireless AP) In the case of disabling wireless broadcast (that is, SSID broadcast), the use of TP-LINK wireless network card to connect to the wireless signal has the following two methods:

Take the signal name: zhangsan, encryption method: WPA-PSK/WPA2-PSK, wireless password: 1a2b3c4d as an example.

Method 1: Using TP-LINK client software to manage wireless network

After front-end wireless signals are hidden, the network is not found on the TP-LINK client software, you must manually add the configuration file, the method is as follows:

1. Open the TP-LINK client software, click Configuration file, Click Add, As follows:

2. In the displayed dialog box, set all parameters. Note that the network name and security key must be consistent with the hidden signal name. After setting, clickSave. As follows:

3. Return to the configuration file, select the previously added configuration file from the list, and clickConnection, As follows:

4. The system prompts you to activate the configuration file. ClickOK, As follows:

5. After the configuration file is successfully activated, clickStatusTo view the information after successful connection, as shown below:

At this point, the hidden wireless network settings are connected through the TP-LINK client software, after the network connection is successful, closing the client software does not affect the wireless connection.

 

Method 2: Use Windows to manage wireless networks

Click the network icon in the lower-right corner of the computer. In the displayed signal list, findOther networks, ClickConnection, As follows:

Note:: If the operating system is Windows 8/8. 1/10, the connection name isHide the network.

In the displayed dialog box NameEnter the wireless signal name and click OK, As follows:

InSecurity KeyEnter the wireless password and clickOK, As follows:

After a moment, the wireless connection is successful, as shown below:

After the signal is successfully connected, as long as the front-end network parameters remain unchanged, the system will automatically connect to the signal after it is started.