TP Router wr866n How to set network permissions

TP Router wr866n The first step in setting network permissions and setting up a daily schedule

A small business needs to realize that the manager's computer is unrestricted, all employees can only access specific websites and applications during working hours, and there is no limit to the Internet at any other time. According to the requirements, make the following configuration table:

Note: The above parameters are for reference only and are defined according to the actual requirements when setting the rules.

Login to the Router management interface, click on the Internet Control >> Schedule >> add a single entry, adding working hours, as shown in the following figure.

Follow the same setting, adding rules for other time periods in turn, with the following general rules.

TP Router wr866n The second step in setting network permissions, setting access targets

1, fill in the target site domain name

Click on the Internet Control >> access target >> add a single entry to the company site domain name (take www.tp-link.com.cn as an example), as shown in the following figure.

2, fill in the target IP address

Add the access target to add the DNS service as an example.

Note: You can also select the service you want to set up in the common service port number.

3. Add other rules

Use mail client software to send and receive mail, commonly used ports are: 25, 110, 53, Smtps Port 465, imaps Port 993,

QQ login commonly used port: 8000,443.

Add the rules in turn, as follows.

Note: The relevant parameters of this article only for example, the specific open port and destination IP address, to the actual demand.

TP Router wr866n Set the third step of network permissions, set the host list

1, add Manager computer

Click on the Internet Control >> host List >> add a single entry, adding the manager computer's Mac, as shown in the following figure.

Note: Set the manager's MAC address to avoid other computers that modify IP addresses to gain access to the Internet.

2, add the staff host

Because of the number of employees MAC address, add to the rule list will multiply, can be achieved by IP address segment, the following figure.

Note: The IP address may include the manager's IP address, which, according to the matching rules, does not conflict.

Set the rules as follows.

TP Router wr866n Set the fourth step of network permissions, set access rules

1, add Manager access rules

Click on the Internet Control >> rule Management >> Add a single entry, add Manager computer access rules, as shown in the following figure.

2, add staff to the Internet rules

Add an employee Internet access rule to add a work time rule as an example.

Add the access rules for employees to send and receive mail, log on to QQ and non working hours in turn, after the setup is complete, the general rules are as follows.

TP Router wr866n Set the fifth step of network permissions, set access rules

After setting all the rules, click to open the Internet control, the default filter rule to select "usually in line with the set of Internet control rules of the packet, allow through this route", click Save.

Note: The default rules selected here are filled in according to actual requirements, "allow" is the set of rules for the white list, "Prohibit" is the set of rules for the blacklist.

At this point, the Internet control function settings completed. All computers in the office network will be applied to the Internet according to the rules set.