tp450g router How to set AC function to manage AP

tp450g Router set up AC function Management AP Case Analysis

For maximum cost savings and convenience, we integrate the AC function (centralized control wireless AP) into the router, so that the perfect coverage can be achieved with the router +ap. The following figure.

This article describes the use of tl-wvr450g and wireless AP.

A training organization ABC needs to decorate the wireless network that can connect 100 people, set up the staff wireless and student wireless network, and control different person's network authority.

Attention. The above parameters are for reference only, the actual application is the subject.

tp450g Router set AC function manage AP First step, connect AP

Different types of AP power supply methods may vary, including DC power supply and network cable power (Poe power supply) two kinds. As follows.

[1] DC power supply.

Use a self-contained power adapter to power the AP, requiring the AP to be placed at a power outlet, with the advantage of cost savings. Connect according to the topology map.

[2] Cable power supply.

The use of network cable to the AP power supply, simple, beautiful, but required with a POE switch (power supply), the cost is high. The following figure.

tp450g Router set AC function Manage AP Step Two, configure address segment

In order to facilitate the control of the students and employees of the Internet access, preconfigured address segments, if you do not need to go directly to the next step.

Log in to the router management interface to add address segments to the object management >> IP address pool.

The default already has an employee network address segment office_2.4g and office_5g, add a guest address pool. As follows.

Attention. If the guest address segment address is insufficient, you can shorten other address segments.

tp450g Router set AC function manage AP Third step, configure wireless parameters

Below we only take the 2.4G wireless setup as an example, the actual use of 2.4G and 5G as needed.

Enter the wireless management >> wireless basic settings and modify the default entries in the Wireless networks list as follows.

Follow the instructions below to set up an employee network.

Add a student wireless network as follows.

Attention. Students are not allowed to access each other, you can open internal isolation.

After the addition is complete, the list is as follows.

Follow the settings above to set the 5GHz wireless basic settings as well.

tp450g Router set up AC function management AP Fourth step, AP Management

When the line is connected, AP can be found in wireless management >> AP Management. As follows.

Click on the corresponding AP to modify the key, modify the corresponding settings, as follows.

After the modifications are as follows.

According to the above steps, set up other AP, the follow-up can be convenient management control.

Finally, click Save Configuration.