Why use
DMZ
Host?
To open an intranet server, use the DMZ host. For example, there is a server that shares resources in the intranet to provide resources for Internet users. You can set the DMZ host to open the server to the Internet.
Of course, if the server's service port is fixed and easy to set, we recommend that you use a virtual server.
The DMZ host is as follows:
This topic describes how to configure a VM instance.
Log on to the vro management page and click
Device ManagementTo go to the management settings page, as shown in the following figure:
Find
DMZHost, ClickEnter.
Click
Open, Enter the server IP address in the DMZ host IP address, and click
Save, As follows:
The IP address of the server. You can view the IP address at the local network card of the computer or select from the connected device.
So far, the DMZ host settings are complete.
To access resources shared by the server over the Internet, you must use the IP address of the WAN port of the router. In
Route settings
>
Network ParametersView, as shown below:
When accessing resources, you only need to access the WAN port IP address as follows:
After the settings are complete,
DMZ
Cannot access the host?
Troubleshoot the following issues:
1. Confirm that the server is successfully built, that is, the intranet can be accessed normally;
2. Confirm that the server IP address entered in the DMZ host is correct;
3. Directly connect to the server through broadband and configure the Internet to ensure normal Internet access;
4. Try to disable the server firewall.