Upgrade the tftp method of the Belkin Router

When using a vro to access the Internet, many netizens always hope to have a better experience on the Internet, while updating the vro software can solve some router faults and obtain the latest functions. 1. download the latest Image file. download the latest Image file from the Belkin official website and create an English folder under the root directory of the disk, put the following Image file in it. 2. Prepare the router to power off the Belkin router. Use a tooth sign and other sharp points to insert the reset hole. Press and hold the button to enable the router power and press and hold the WPS button, observe the power light. Do not let it go until the power light changes from orange to green. This indicates that the device has entered the TFTP repair mode. Connect the computer with a network cable to the LAN port of the router, set the IP address of the computer to 192.168.1.X, And the subnet mask to 255.255.255.0. Do not set the IP address for other projects. Www.2cto.com

3. Send the firmware Image file to the Belkin router (1). In the XP system, click Start-run in the lower-left corner of the computer, Enter cmd, and click OK. Go to the Save path of the upgrade file, and enter the doscommand: tftp-I 192.168.1.1 PUT WNR1000v2-V1.0.1.1.img, pay special attention to the DOS command case sensitive, press Enter. (2) Linux system input command: tftp-m binary 192.168.1.1-c PUT WNR1000v2-V1.0.1.1.img. Wait a moment to complete the upgrade. After the file is transferred, the device restarts automatically. If the restoration process is interrupted or fails, repeat the above steps to try again. This article is from