USB high definition isolation oscilloscope, virtual oscilloscope, technical features and applications

USB high definition isolation oscilloscope, virtual oscilloscope, technical features and applications
USB oscilloscope market leader, model HS5, HS6, cs448 four-channel high definition isolation oscilloscope. The instrument has four differential input channels and a variety of probes that can be used for measurement in a variety of applications from ml v to 1000 V cat III. The new oscilloscope solves the long-term problems of accurate voltage waveform Measurement on non-grounded reference circuit components, so that electrical engineers can freely perform Differential Voltage Measurement in the case of common mode signals, the new instrument has MHz Analog bandwidth, 14-bit ADC, 1-bit ~ 1000 ms/s sampling rate, up to M capture memory, inter-channel, 1kv catiii voltage isolation between the channel and the reference location, Common Mode Rejection Ratio CMRR up to [email protected], two cs448 devices can be cascaded into eight channels to isolate the oscilloscope.

HS5, HS6 virtual oscilloscope ...... cs448 isolation oscilloscope
HS5, HS6, and cs448 are a 4-channel isolated (high common mode rejection ratio) oscilloscope that allows you to conveniently measure all the signal characteristics of a single-phase/Three-phase switched bridge circuit. For example, you can measure the voltage and power of the MOS gate drive, the loss and parasitic characteristics of the switch, the output power and spectrum measurement (EMC consistency test), and the gain/phase and Stability of the control circuit. Cs448 contains a signal generator with an isolated output to generate an incentive signal and an 8-channel logical analyzer to measure the control signal. The two HS5, HS6, and cs448 machines can be connected to the Master/Slave cascade, and the sampling clock is locked into an 8-channel isolated oscilloscope.
HS6 and cs448 quad-channel high definition isolation Oscilloscope with MHz bandwidth, 14-bit ADC, isolation voltage between channels-reference locations up to 1 KV cat III, common mode rejection ratio up to CMRR [email protected]

Cs448 USB isolation oscilloscope
Application of switching Bridge Circuit

Measurement results:

Multi-Channel Measurement: hs4, HS6 virtual oscilloscope
Electronic Engineers often need to perform various low-voltage measurements in the case of high common-mode noise or changing offset voltages. The ground reference oscilloscope requires two input channels and a mathematical function of the A-B to observe the differential signals of interest. However, because two input channels are required, most of the scopes do not have a high common-mode rejection ratio (CMRR) and do not have the resolution required for fully accurate measurements. Engineers working on multi-phase distribution systems need to measure the AC voltage, rather than the voltage between phases. The ground reference oscilloscope cannot be used because it causes a short circuit. External differential probes are a solution, but they are expensive and bulky, and each probe must have its own power supply. The HS5, HS6, and cs448 four-channel high-definition oscilloscope provides isolated differential input and various probe options to solve these problems at the same time. The newly designed FET probe system accurately collects high voltage and rapid rising edges (voltage changes within 10 ns up to 500 V). HS5, HS6, and cs448 also maintain other superior performance of high-end oscilloscope products, built-in Signal Source with isolated output, logic analyzer, protocol analyzer, Frequency Response Analyzer, impedance analyzer, data recorder, etc. In addition, the standard USB interface, built-in SD card interface, and Gigabit Ethernet (or Gigabit Optical Fiber Interface) Further improve the data transmission/storage capabilities of HS5, HS6, and cs448 www.pc17.com.cn

USB high definition isolation oscilloscope, virtual oscilloscope, technical features and applications