Use insulated wire puncture clamp live working method to operate on three-door hanging Network

On April 9, May 15, on the 18 # pole of the qinjiang 524 line in the West District of Sanmen County, the O & M Department staff of the Power Supply Company were using insulated operation poles for the first indirect live working on the overhead insulated wires. In an hour, they successfully completed the task of installing a new insulated wire puncture clamp and mounted the network on the power distribution line. This is the first time in the province to adopt this new technology for installation.
This work is led by the O & M Department of Taizhou Power Supply Company, which organizes three power supply companies, Linhai Power Supply Company, Huangyan Power Supply Company and related factory technical personnel as the power supply department's 2014 technology implementation project. In the past, the indirect live working method of insulated operation rods can only be carried out on bare wires. This new type of puncturing clamp adopts complicated operation techniques, which are difficult to work and greatly consumes manual labor, however, the pilot work on that day was successfully completed with sufficient preliminary preparation and on-site technical staff efforts.
This technology fills in the gap in the installation method of the operator bar of the needle in the live working wire on the power distribution line, in particular, it is applicable to live-working of overhead insulated lines in road-ground conditions and live-working vehicles that cannot reach the location, eliminating the dead corners of live-lap power distribution. Www.chinaxianjia.com