Use Photoshop to add HD glow color to the gray backlight city picture

Original

< small map view big picture >

Final effect

< small map view big picture >

1, open the material picture, select the cutting tool to cut the screen, select the part you want.

2, add color. The impact factor of the screen is many, color is very important one aspect. Because it is morning, the screen fog is very large, sometimes the backlight photography color is more gloomy. There are many ways to add color, the use of "application Image", the application of image than layer mode, it has a mask to protect the dark part. Copy the background layer, execute: image > Application image, and set the parameters as shown below.

3, add mask to restore the dark part, the foreground color is black. Select Black to transparent linear gradient. Gradient from the bottom of the image to pull up, pull the time if not in place, the amount can be pulled several times, until satisfied.

4, add color and contrast. In the above processing, although the color and contrast increased, but did not reach the desired color, this operation is to convert the photos to lab mode, by adjusting the curve to increase the color, the following figure.

5. Increase the level of contrast. You can download an HDR external filter individually, and you can increase the contrast and sharpness after the photo is tuned.

6, after the image of HDR processing a lot of noise, using Noiseware professinal plug filter to sharpen, the following figure.

Final effect:

< small map view big picture >