Use Photoshop to give black and white portrait with extremely smooth glaze porcelain skin

Original

Final effect

1, open the material picture, the background layer to copy a layer. This step to eliminate eyebrows and eyelashes. Select the Clone Stamp tool to remove eyebrows and eyelashes, it's a little tricky. But you have to be careful, do not damage the edge area, I spent 15 minutes here, look at the production before and after the contrast chart.

2, copy the layer, select "Filter > Sketch > Ming Huang", set the details to: 0, the smoothness is set to: 10, and then click OK. Set the blending mode of the layer to "multiply" with the opacity set to 15%.

3, this time to find some dirty face, details too much, then add a layer mask to her, use the soft angle brush will mouth, chin and other places of some details hidden, of course, where to hide what location also depends on your choice of photo resolution.

4, the completion of the above parts feel very cool color, the following to make eyes, using the "elliptical marquee tool" to draw an eye, color can be arbitrary.

5, to draw the eyeball to add layer style, the following figure adjust the options below.

< inner shadow >

< Inner glow >

< color overlay >

6, create the pupil, use the elliptical marquee tool to draw the pupil and add black, and then use the Pen tool to draw a white high light. Then use the "Gaussian blur" for the high light and set the radius to 1 pixels to soften the point.

7. Create a new layer, use the Ellipse tool to draw an ellipse in two-thirds parts of the eyeball, then fill it with white, set the blending mode to "overlay", and then set the opacity to about 50%.

8, here to customize a brush. Use small white brush, press F5 to open brush Editor, set dynamic size jitter to 85%, scatter in the scatter of 1000%, new layer on the eye to draw white dots, the layer blending mode set to "overlay."

9. Use a soft angle black brush to draw shadows on the upper part of the eyeball.

10. Create a new layer and use the elliptical marquee tool to draw an ellipse based on the eyeball and fill it with black. Select Filter > Noise > Add noise, set the quantity to 400%, and then set the layer blending mode to overlay.

Use the same method to make the left eye and finish the final effect.