Using Flash to make analog film loop playback effect

Cycle

Watch animation effect:

Objective:

The main introduction of flash simulation of the film cycle effects, and how to connect the MC starting, the beginning of the connection to achieve the visual effect of circular playback.

1, set the file size as shown below. (This is based on the required size of the banner)

02, new components, and in the components to draw the background of the film Tooth card effect, and converted into MC components. Here need to note: The distance between the teeth card is even, to avoid the playback of breakpoints or uneven connection

03, guide Picture warehousing.

04, a new MC, in the MC layer 1 Insert Picture, Layer 2 into the tooth card MC and aligns layer 1 in the MC

I set up 3 groups of MC, respectively, mc1,2,3 (5 for a group).

05, back to the scene, in the first layer at the 1th frame, insert MC1, so that the center in the scene

And at Frame No. 600, move out of the scene.

06, back to the scene to create a new layer 2, and in Layer 2 at the first frame insert MC2 (next to the layer one in the MC1 end)

At frame No. 600, move and change the MC1,MC2 position (at which point MC2 is in the scene, MC1 moves out of the stage)

1200th frame, move and change the MC2 position (out of the stage)

07, with a similar sixth-step production method, the production of the 3rd layer MC3 effect.

Insert MC3 in Layer 3, 600 frame, 1200 frame, 1800 post, move change see step reference

08, where I think the most important place here: how to avoid the possibility of a gap between the

New Layer 4, insert MC1 (frame 1200th). The location is as follows:

The 1800th frame is located as follows:

Insert the following code at frame 1800th:

Gotoandpaly (2)

09. Ctrl+b Carriage Return Test