Vro broadband speed limit: the configuration process is illustrated in the figure below.

Introduction to vro broadband speed limit setting Environment

Before you set the bandwidth limit for a vro, you need to know how much bandwidth we have subscribed to, and how many computers have shared the bandwidth. Here we first use our bandwidth as 2 M, when two people use the IP address at the same time and use automatic retrieval as an example to set the router bandwidth speed limit.

1. Set automatic acquisition of IP addresses

Set the main parameters of the router first.

DHCP server: Enabled

Address pool start address: 192.168.1.2

Address pool end address: 192.168.1.3

Gateway: 192.168.1.1

Set the computer.

Right-click the network neighbor -- properties -- local connection -- properties -- double-click cp/IP protocol-> automatically obtain the IP address

Ii. vro broadband speed limit settings

1. Set IP bandwidth control

Check Before enabling IP bandwidth control. bandwidth Line Selection: ADSL line, uplink total bandwidth: 1024, downlink total bandwidth: 2048 (2 m here is 2*1024, 4 m is 4*1024), it is best to click "save ".

2. Set the IP bandwidth control rule list

I want to limit the bandwidth of two computers here, so I need to set two rules when setting. If you have already set the broadband speed limit of the router, you need to delete all the original settings and click Delete all entries ).

Add a new entry> Configure an IP bandwidth control rule (modify the following parameters and use the default settings for others ).

Check if the IP address range is 192.168.1.2-168.192.1.2, upstream: 512, downstream: 1024 (this is the bandwidth limit value, and 1024 indicates that the bandwidth is evenly allocated, you can also set a slightly larger value of 1200), and then click "save" after setting all the parameters ". Then add the second-level rule, add a new entry-> IP bandwidth control rule configuration, enable (tick), address segment 192.168.1.3-192.168.1.3, upstream: up to 512, downstream: up to 1024, as above, click "save" after setting ". Finally, to prevent others from modifying the IP address, we can add another rule, fill in 192.168.1.4-192.168.1.4 in the address segment, set upstream to 10, and downlink to 100.

The process of setting the vro bandwidth speed limit ends here. You must pay attention to many details when configuring the vro bandwidth speed limit, for example, some parameter requirements, we hope you can achieve it successfully.