We recommend that you use BIOS settings, hard disk partitioning, system installation, and full backup diagrams! Page 1/6

BIOS settings for most computers, when the boot, the screen will have such a prompt-"Press DEL to enter SETUP ".

CTRL + Mouse wheel to zoom in/out "> it means" press the Delete key to enter the CMOS Settings ". At this time, we press the" Delete "key on the disk.

This is the interface for CMOS settings.

CTRL + Mouse wheel to zoom in/out "> different computers may have different interfaces, but AWARD, AMI, Phoenix, etc. Although the Interface format is different, the function is basically the same, and the project to be set is similar. This is the most obvious CMOS setting screen of AWARD. As a matter of fact, you only need to understand a CMOS setting method. Other methods can bypass the class. There are many parameters that can be set below them. Most of the items have already set correct parameter values, or many of them have little influence on computer operation in advance, therefore, we only need to pay attention to several key items. What are the key items? Generally, when setting CMOS, I simply do the following steps: 1. Set the optimal value; 2. Check hardware parameters; 3. Set the startup sequence; 4. Set a password if necessary. 5. Save the settings and exit. Use the four arrow keys on the keyboard to select various menus on the interface.

In addition, the following area shows the parameters that can be set in the selected menu.

CTRL + Mouse wheel to zoom in/out "> set the best setting value. You can see that this" load Optimized Defaults "is" call the best setting value ", that is, the optimal settings under normal circumstances.

CTRL + Mouse wheel to zoom in/out "> move the cursor over this item with the up and down arrows, and press Enter. The screen prompts" whether to load the default value"

If an exception occurs on your computer, you can use the "Load Fail-Safe Defaults" command to restore the default BIOS value. This is the most basic and secure setting. This setting usually does not cause setup problems, but the computer performance may not be fully utilized,

CTRL + Mouse wheel to zoom in/out "> for the parameters of the main accessories, we need to check the parameters of the main accessories to determine the hard drive, optical drive, and soft drive, and whether the main hardware such as memory is installed normally, and sometimes the hard disk needs to be checked. Move the cursor to the first item "Standard BIOS Features" and press Enter.