1, we first remove the mouse, the mouse foot stickers all opened up on the exposed screw hole. Altogether 5 screws. Pay attention to the foot stickers do not throw and also useful
2, after opening this is the appearance of the attention do not break inside the line. Otherwise it's going to be welded.
3, then we do not pick off the line. Also do not care about the inside of the mouse circuit board and so on. We just need to move up and down the shell.
4, remove the four screws on the lid can be unloaded.
5, after the demolition down to become this appearance. Our general G500 is because the top shell is prolonged by the lack of elasticity caused by the collapse. So we'll fix the problem by giving him a little bit of a cushion. Like the yellow position under the picture.
6, now we reserve two hand-foot stickers to come in handy. We cut the foot into a rectangle, and the two floors are fixed in the red area of the image below.
7, the next step is to twist back to the screws, restore the previous appearance on it.
Note:
1, this method is suitable for the mouse, and no tool to change the micro-move friends. After they have been opened, there will be no insurance.
2, pay attention to the screws do not lose, it is difficult to find AH.