Test tone Generator How to use:
After the software is installed, first run the output SETTING in the tool, then according to the picture, select 44100HZ, the following blue box to select the largest buffer
Then go back to the main screen, tool--the purple box, run the test
Frequency and time set for the headset:
Divided into four stages
1, use the normal listening intensity One-third Volume drive headphones 24 hours (with 100~15000hz/5s sine sweep frequency signal better)
2, use the normal listening intensity Two-thirds Volume drive headphones 24 hours (with 50~18000hz/3s triangle sweep frequency signal better)
3, the use of normal listening intensity to drive headphones 24 hours (with 20~20000hz/2s square wave sweep signal better)
4, use the normal listening intensity Four-thirds Volume drive headphones 24 hours (with 18~22000hz/1s white noise sweep frequency signal better)
Note that the volume should not be too large, and it is best to let the headphones rest for a few minutes or so every two hours.
Specific settings:
In the red box on the left of the figure
SINE ——-Positive Xuan Wave
square--Square Wave
triangular--Triangle Wave
White noise--noise (this seems to be unable to choose frequency--)
Blue Box
Loop= Cycle
stereo= Stereo
SAME at left= and left channel settings are the same
Hz number according to the mentioned self-filling can be
Note: The software cooker headset is risky, please pay attention to the volume size and time
Note : More wonderful tutorials Please pay attention to the triple computer tutorial section, triple Computer office group: 189034526 welcome you to join