What to do when you reboot the computer prompting cannot load file

The use of the U-disk installation system you should have known, but after the installation of the system after the problem is endless, today's small set up in the system to colleagues appeared "

Error:cannot load file (code:5555h): "

No prompts to enter the system. What the hell is going on here?

As shown in the figure above

is a small series in the reload system after the restart of the computer prompts!

Error:cannot load file (code:5555h):

Bootghost.ini

Press any key to boot from hard disk or ESCape to reboot ...

Now you start the small series and everyone together to analyze the causes of this problem and the solution!

Reason Analysis:

Before using the U disk to install the system, we will go to the BIOS to set USB as the first boot, and after the installation of the system will sometimes forget to set the first startup item back to the hard drive to start, so this problem arises!

Solution:

Since we already know the cause of the problem, the right remedy is a simple matter.

Reboot the computer and press the appropriate shortcut key to enter the BIOS setup. Keyboard shortcuts for computer access to BIOS settings are generally

ESC, F2, delete, and so on, you can try different buttons to see whether to enter the BIOS settings.

Locate "boot" in sequence under BIOS settings

→

"Boot Device Priority"

Press ENTER to confirm, select "Hard Disk Drive" under the pop-up window

And through "Page up" on the keyboard

Move it to the top (first option) and press "F10"

Save and exit, as shown in the following illustration:

After reloading the system, many users will forget to set the startup item back to the hard drive in the BIOS, so it will cause a problem like this when the computer starts, but there is no need to panic if you have to go to the BIOS to set the hard disk as the first boot.