When ThinkStation is started, Wait DONE bit timeout and diagnostic feature Config fail errors may occur.

Fault symptom:

ThinkStation p5001_p70020.p900host to update the fn03_v51__s1606.exe firmware. After the firmware is changed, the error message "Wait DONE bit timeout, diagnostic feature Config fail." may appear when the device is started.

Cause analysis:

This is because the SiO2 firmware update requires a power-off cold start to take effect. In the case of hot start, the error message is displayed on the next startup interface, not a hardware fault.

Solution:

1. Shut down the system and disconnect the V power supply.

2. Reconnect the power cord and start the system.

Note:

Applicability:

P500, P700, P900

Windows 7, Windows 8, Windows 8.1, Windows 10