Win7 Add usb3.0 Driver (Error code 1392, file or directory is corrupt and unreadable)

Win7 adding USB3.0 Drivers

Always fails when the DISM command is mounted in accordance with the online method, error code 1392 is displayed because the file or directory is corrupted and cannot be read. This error was always installed at the time of the installation of the system is not successful, in the BIOS to change the hard disk mode to IDE mode (Compatible mode) can be, this time, changed after the decisive can be. However, the hard drive mode is changed from AHCI mode to IDE mode, and then the blue screen is started when Win7, and it is done in the Win7 PE system.

Summarize the reasons for the failure:

1, may really be related to hard disk mode.

2, when the WIM is all done, and then in the previous Win7 hung just do a good WIM, unexpectedly mounted successfully, no error (at this time the hard disk mode is AHCI mode), no language ... Is there any real damage to the WIM file before ... No solution.

First, download the driver of usb3.0.

The version downloaded here is the Intel (R) _usb_3.0_extensible_host_controller_driver_3.0.4.65.

Second, in the E-disk (must be system disk) to establish the Win7 folder.

1, in the Win7 folder to build mount, Usb3_x86, usb3_64 three folders, and the original system image ISO Boot.wim and Install.wim (UltraISO from the sources directory) copied to the Win7 directory.

2, the download driver file decompression, in the driver file has a Drivers folder, folder has Hcswitch and Win7 two folders. Each of the two folders has x86 and x64 two folders, the file one by one in the corresponding copy to the E-drive under the Win7 directory usb3_x86 and usb3_x64 directory, a folder is 12 files.

Third, add the usb3.0 driver (run the command in CMD, run as Administrator).

1. View information:

Dism/get-wiminfo/wimfile: "E:boot.wim"

2. Mount:

Dism/mount-wim/wimfile:boot.wim/index:1/mountdir:mount

After mounting, you can see the files in the Mount directory.

3. Add Driver:

Dism/image:mount/add-driver: "Usb3_x86"/recurse

4. Save Uninstall:

Dism/unmount-wim/mountdir:mount/commit

If you do not save, use the/discard parameter.

5, repeat the steps 2 to 4 will also add the index 2 driver.

Iv. Install.wim file operation is the same. Note the change command/add-driver: "usb3_x64" when adding 64-bit drivers.

V. the errors encountered.

Workaround: Create a new directory to be re-hung.

Workaround: The previous mount was unsuccessful, the directory was removed clean and then hung successfully, but all later save the problem again. It's better to create a clean directory.

Win7 Add usb3.0 Driver (Error code 1392, file or directory is corrupt and unreadable)