Win7 system how to set up and debug game handles
1, first in the computer host insert handle, such as the computer installed its own drive, in the "Start" menu, select "Equipment and Printers" to set;
2, open "equipment and printers" after the selection of computer-connected game handle icon;
3, right key game handle's icon to set up. Then click the "Properties" button in the lower-right corner of the "game controller" setting interface.
4. Under the "Test" tab, we can test whether the buttons of the handle are working properly. First, you can rotate and press the left rudder and direction button in the handle to see if the cross cursor movement above the x-axis/y axis is normal. The final cross cursor should be centered. Remember that all the keys to the handle are tested again! Lest there be a key broken down the passion of playing the game is bad;
5, if the above test handle problem is not normal, it is necessary to calibrate the game handle. (Small series is professional!) You can calibrate the game handle by selecting the "Calibrate" button feature on the Settings tab;
6, enter the "Equipment Calibration Wizard" followed by the prompts click "Next";
7, in the "calibration axis" interface, will handle the left rudder rotation a few laps, reposition center point. This process is calibrated to the "x-axis/y Axis" of the game handle;
8, the final adjustment of the z axis calibration procedures. Move the z axis from top to bottom, i.e. the right rudder on the moving handle to calibrate. The z axis is then rotated to calibrate. Z axis after the calibration will automatically jump to the following interface, click the "Finish" button can be normal use of the handle.