WIN7 System wireless Router how to bridge

　　 The specific steps are as follows:

　　Step one, configure your PC environment

1, in order to ensure the correct and integrity of the subsequent wireless bridge configuration, it is recommended to connect the router with a network cable and set the IP (IPV4) of this computer to be fixed, and ensure that the fixed IP is the same network segment as the main router IP.

2, click the "Start" button, enter "cmd", press ENTER, and then enter the command "Ipconfig/all" Query this machine detailed configuration information:

Record the IP, subnet mask, default gateway, especially after DNS, which is used later.

3. Right-click the network icon in the lower-right corner of the taskbar and choose Open Network and Sharing Center:

4. Click "Local Area Connection" in the pop-up window:

5, in the Open Local Connection Status dialog box, click the Properties button:

6, click Internet version 4 (TCP/IPV4) in the Local Area Connection Properties dialog box, and then click the Properties button:

7, in the Open dialog box to use the dynamic IP information obtained above to configure the fixed information:

Note: The default gateway is the primary router IP;

8, after the configuration is completed, it is best to restart the computer, and then open the outside network, verify whether the external network. This reduces the scope of troubleshooting when the problem follows.

9, or through the network and Sharing Center to see the connection between the router and the external network is normal:

　　Step two, main router configuration

1, assuming that the router used to connect to the external network as the first wireless router, we will this router as the primary router. Its wireless name (the SSID) is defined as TP-A, and its IP is 192.168.0.2.

2, the main router tp-a need to turn on the DHCP service, do not need to enable the WDS feature.

3, open the browser, enter the main router management IP "192.168.0.2", and then click "OK" into the background management interface:

4, after landing on the left to select the DHCP server, and then select the DHCP service: