WIN8 System use command prompt to modify IP address method

There are a number of ways to configure IP addresses under Windows operating systems, typically we will directly modify the Ethernet TCP/IP, but many users do not know that the WIN8 system can modify the IP address through the cmd command line, modify the IP address through the command prompt is not only convenient, And also not easy to network failure, the following we detailed the WIN8 system to use the command prompt to modify the IP address method bar!

WIN8 System use command prompt to modify IP address method

1, open the command prompt, enter Netsh return

2, then enter interface after the return

3, input IP, carriage return

4, enter set address "connection name" static new IP Address Subnet Mask Gateway 1, and then enter

Note that the above command needs to be modified in accordance with user requirements, the connection name can refer to the "Network connection" in the name modified to support Chinese, but the quotation marks in English. There must be a space between each item, and finally enter "1" to represent the determination. You can refer to the following example:

Set Address "Ethernet 3" static 192.168.1.108 255.255.255.0 192.168.0.1 1

5, you can also put the above command at a one-time input, but to ensure that do not wrap: netsh interface ip set address "connection name" static new IP subnet Mask Gateway 1

Example: netsh interface ip set address "Ethernet 3" static 192.168.1.108 255.255.255.0 192.168.0.1 1

In addition, you can use similar commands to modify DNS, the same format as above, as long as the "address" replaced by "DNS" can: netsh interface ip set DNS "Ethernet 3" Static DNS address

It should be noted that the system IP becomes static after the modification. If you do not meet the needs of users, you can use the system's own Network "Troubleshooter" for automatic repair, restore dynamic IP. Of course, the IP address can also be restored by the command netsh interface ip set addressing "connection name" DHCP, and DNS addresses can also be recovered by command netsh interface ip set DNS "connection name" DHCP.

Through the above method, we can quickly configure the native IP address at the cmd command prompt, so it is more convenient to use the traditional network and Sharing center settings, and the user who likes the article quickly collects it!