Wireless network card connection is not how to solve

Wireless network card connection is not how to solve

Wireless network card

Wireless network card is not connected to the reason analysis:

Line and routing problems that can result in wireless automatic network disconnection

1, first check the line quality, including telephone lines and power lines, to see if there is no contact with the phenomenon of bad, wire quality should try to choose the quality better.

2, the voltage is stable, whether the vicinity of the start, the load is relatively large, relatively strong radiation power equipment.

3, the power adapter quality and voltage to meet the requirements, conditions for a look.

4, the occurrence of disconnection is easy to answer the phone when you can determine the quality of the telephone distributor and wiring mode is not a problem, you can change to see.

5, the above no problem is only suspected routing quality problems, this can not be repaired, you may find a route to see if there is any improvement.

Signal transmission and network card problems, may be the reason for wireless automatic disconnection, the above reasons can be ruled out, it can only be set up a method of the problem, you can look at the following wireless network card connection settings instance.

Wireless network card

Check the wireless Card connection settings

The following are the main steps:

1, the installation of wireless network card driver, see the device management drive whether there is "!" That is to make sure that the driver is properly available;

2, check the Internet card has a hardware switch or software switch, placed on the state, software switches in the advanced properties of equipment, general installation is open after the state;

3, is the AP access password is required, need to set;

4. Is the IP allocation policy dynamic or static? Dynamic settings are automatically obtained (set in Network properties), the static settings need to determine IP, gateway IP, DNS and so on.

Instance:

Netizen Question consultation: Wireless network card is not connected to the Internet. The connection display is very good, is not open the website

Please follow these steps:

1. Open your network place to see if the wireless network connection is showing the connection. If OK, then next.

2. View the wireless network connection properties, IP and DNS settings for automatic acquisition. Of course, the premise is that your own routing or corporate routing to open the function of dynamic IP, otherwise, you need to set up or to your administrator to apply for a fixed IP address. Deactivate the local connection at the same time.

Wireless network card

3. If OK, then next: Ping your gateway address, generally 192.168.0.1.time display data, then the route is normal.

Wireless network card

4. Select the connection in Internet Options--"LAN Settings-" automatic configuration.

If you are dialing the Internet, select Settings-"Automatically detect settings."

Wireless network card

Then all can be normal Internet. Of course, if your wireless connection has a password, does not go in, or you do not have access to the network, it must not be in.