When the boot, you need to press F1 (or F2) key before you can continue to start, please verify the following error:
Phenomenon 1, post, "Pri Master Hard disk:s.m.a.r.t. Status bad,backup and Replace Press F2 to Resume"
This fault is a hard drive failure, it is recommended to back up the data and repair.
Phenomenon 2, post, reported "SMART failure predicted on Hard disk,press F1 to Continue"
This fault is a hard drive failure, it is recommended to back up the data and repair.
Phenomenon 3, Post, reported "CMOS Date/time not set,press F2 to Run setup,press F1 to load default values Andcontinue"
If the notebook has this error, please turn on the computer and enter the BIOS setup. Press F9 to restore the default value, reset the CMOS date and time, press F10 Save exit, shutdown power off and unplug the battery, placed for a period of time after the boot test; if invalid please click F1 in this interface, enter the system after the upgrade anti-virus software, comprehensive antivirus; If still invalid, please repair.
Phenomenon 4, post, the newspaper "0271:check Date and Time settings, press F1 to resume, F2 to Setup"
If the notebook has this error, please turn on the computer and enter the BIOS setup. Press F9 to restore the default value, reset the CMOS date and time, press F10 Save exit, shutdown power off and unplug the battery, placed for a period of time after the boot test; if invalid please click F1 in this interface, enter the system after the upgrade anti-virus software, comprehensive antivirus; If still invalid, please repair.
Phenomenon 5, post, the newspaper "02f0:cpu id:55 No microcode Update Loaded for alternate Processor"
Please check and unplug all external devices, such as memory cards, card reader and other USB devices, at the same time, if you have your own upgrade hardware, please recover after testing, if invalid, please boot and enter the BIOS settings, press F9 restore the default value, press F10 save exit, shutdown and then boot test, if still invalid, please repair.