Zonet Broadband Router eMule port ing settings

E-mapreduce has been fascinated by eMule in recent days. However, when I access the Internet through a vro at home, I always get a lowid and the speed is low. Verycd website is introduced to some of the NAT method (http://www.emule.org.cn/topic/nat/), But I zonet Broadband Router (ZSR-0104) with a lot of people, didn't say in it, had to try it, the success was finally achieved, roughly the same as the port ing settings (http://board.verycd.com/t34337.html) for Linksys series routers.
1. log on to the vro Management page using IP: 192.168.x.x.
2. Select "virtual server" in advanced settings to start the virtual server.
3. Add the TCP and UDP ports used by eMule in the "service port" list that appears (1 ). The IP address of the LAN Terminal Server is the IP address of the local machine.

Figure 1 vro port settings

The port addresses used in Figure 1 must be consistent with those set in eMule (figure 2 ). At the beginning, the default settings of Emule were the same. According to the port settings on the Internet, it was not successful. Later, I found that it was different from my eMule.

Figure 2 eMule port settings

4. Select "Storage & restart"
5. When starting eMule again, it is found that the port is already highid, and the speed is improved a lot.