thermal imaging sensor raspberry pi

The answer is yes. There are 26 pins on the Raspberry Pi Board, these gpio (general purpose I/O) including SPI, I²c, serial UART, 3V3 and 5V power supply. Domestic forum There is an article "RASPBMC Setting Infrared receiver" describes how to install the RASPBMC operating system for Raspberry Pi, install the infrared

, signal pin, and one pin dangling. Connect the Raspberry Pi and module as follows: After checking out the code from GitHub, enter it in the Raspberry Pi terminal lxterminal:CD "Grove–ultrasonic Ranger"sudo python ultrasonic.pyThe Raspberry

distance of the obstacle. The Grove-ultrasonic Ranger has four pins, namely power supply, ground, signal pin, and one pin dangling. Connect the Raspberry Pi and module as follows: After checking out the code from GitHub, enter it in the Raspberry Pi terminal lxterminal:CD "Grove–ultrasonic Ranger"sudo python ultrason

Raspberry Pi on the Cloud (1): Environment preparationRaspberry Pi on the Cloud (2): Uploading sensor data to AWS IoT and leveraging Kibana for presentation1. Sensor installation and configuration 1.1 DHT22 installationThe DHT22 is a temperature and humidity

! [GY-85] (http://images.cnblogs.com/cnblogs_com/hangxin1940/466697/o_gy85.jpg "GY-85 ") 9-axis IMU sensor (GY-85 module) can also be seen as three modules 'itg3205 Three-Axis Gyroscope sensor ''' adxl345 three-axis accelerator tilt sensor ''' hmc5883l Electronic Compass' The GY-85 Module Interface is I2C and can be easily linked to the Arduino/

Yesterday made the control led, played the first, the rest of the feeling is very simple, here recordJust a couple of photos.Play the honey module only to find the law, generally this module, there will be three pins, VCC (3.3V or 5V power supply output PIN), GNC (for Gpio pin of GNC), out/(I/O) (corresponding to the gpio number of pins), if it is necessary to send information to the Raspberry Pi, This modu

Github:https://github.com/hicrater/raspberry-dht11-temperature.gitFirst, look at the wiring Wiring diagram Vcc Cathode Pick up the Raspberry Pi 3.3v power supply (choose one on the line) GND Negative Pick up the Raspberry

Introduced The DHT11 is a cheap accessory that includes temperature and humidity sensors, and the code is easy to use. This article describes if you use DHT11 in a Raspberry Pi, the code is python. If you have any questions, please leave a comment below. Wiring VCC Connection 5V or 3.3V Data is connected to the Gpio (I'm picking up the BCM pin 16th, the physical pin is 36) GND Co

MQ-7 Carbon Monoxide Sensor Module IntroductionBrief description:First, size:32mm x22mm x27mm length x width x HeightSecond, the main chip:LM393,MQ-7 gas sensorThree, the operating voltage: DC 5 VoltsFour, Characteristics:1, with signal output indication. 2. Dual signal output (analog output and TTL level output)3,theTTL Output valid signal is low level. (When the output low signal light, can be directly connected to single-chip microcomputer)4, the a