To give you Photoshop software users to detailed analysis to share a cut down under the tree in the white beauty of the later tutorial.
1, open the material picture, create the optional Color adjustment layer, adjust the green, parameters and effect as shown below. This step puts the green in the picture slightly deeper.
2, the creation of optional color adjustment layer, green, white adjustment, parameters and effects as shown below. This step mainly turns green green in the picture.
3, create hue/saturation adjustment layer, the yellow, green adjustment, parameters and effects of the following figure. This step quickly turns yellow and green in the picture into yellowish brown and reddish brown.
4, press CTRL + ALT + 2 to bring up the high light selection, press CTRL + Shift + I to select, and then create a curve adjustment layer, the RGB, blue channel adjustment, parameters and effects as shown below. This step lightens the dark color of the picture and adds Blue.
5, create a color balance adjustment layer, the shadow, highlight adjustments, parameters and effects of the following figure. This step adds a light red to the picture.
6, the creation of optional color adjustment layer, red, yellow, white, neutral, black adjustment, parameter settings such as Figure 14-18, the effect is shown in Figure 19. This step also adds a light red to the picture.
7, the creation of optional color adjustment layer, red, yellow, white adjustment, parameter settings such as Figure 20-22, the effect is shown in Figure 23. This step adds orange color to the picture.
8, create curve adjustment layer, RGB, red, blue channel adjustment, parameter settings such as Figure 24-26, the effect is shown in Figure 27. This step is a little lighter than the main color of the picture.
9. Press CTRL + ALT + 2 to bring up the high light selection, create hue/saturation adjustment layer, adjust the yellow, set the parameters below, and make sure that the opacity of the layer is lowered appropriately. This step adds a light red to the picture's high light portion.
10, create a new layer, the foreground color set to light red: #F6E4CA, select the Brush tool, brush opacity set to 10% or so, and then the upper left corner part of the front view, the following figure.
11, press CTRL + J to copy the current layer to a layer, blending mode to "filter", hold down the ALT key to add a layer mask, with a white brush to paint the bottom of the selection section.
12, load the current layer mask selection, create a color balance adjustment layer, adjust the high light, parameter settings such as Figure 32, to determine the opacity of the layer, the effect is shown in Figure 33. These steps add a high light to the picture.
13, create a new layer, press CTRL + ALT + Shift + E-stamped layer. Select menu: Filter > Blur > Motion blur, Angle set to 45 degrees, distance set to 200, after the blending mode is changed to "soft light", the effect of the following figure.
14, fine-tuning the character part of the color, mainly skin color part, the effect of the following figure.
Finally, fine-tune the overall and dark color, complete the final effect.
Well, the above information is small compiled for you photoshop this software users bring the detailed tune sitting under the tree of the white beauty of the later tutorials to share the entire content, you see here's Photoshop software users, Small knitting believe you are now very clear of the late tutorial, then now go to yourself to try it.