This is a picture transition effect that we often see when browsing the Web and forums
To make these effects, we naturally think of using the Setmask function to do
In this section we will describe seven basic transition effects
Ideas:
1. Note that a total of three pictures, one is bottom slab (pic_old) on the lowest floor, one is a new map to switch
(pic_new) in the middle layer, and finally a mask layer (mask) for making a new diagram;
2. The new diagram and bottom slab of the depth should not be reversed, the new picture is higher than the bottom slab depth, otherwise there will be errors;
3. We only make the article on the mask, let the mask to load the mask, so you can accomplish many different effects.
Step 1:
(1) Draw a square (50*50), registration point in the center, Save as a movie clip
Connect-> Export-> Identifier REC;
(2) Draw a circle (50*50), the registration point in the center, Save as a movie clip
Connection-> Export-> token Cir;
(3) Import Pictures n Zhang, are saved as movie clips, registration point on the left (0,0)
These pictures are connected-> Export-> markers from Pic1, Pic2, pic3 ... picn