Cisco practice WS-X4232-L3: a small accident

Cisco practice WS-X4232-L3: a small accident a 4006 mount with a WS-X4232-L3 module and the Status of the Management Engine Supervisor II Engine (WS-X4013) turns red, however, it is no problem to observe the offline test of each module during the startup process. Show module does not have the information of the WS-X4232-L3 module, but there is a record to test the module Pass during the self-check process. if you connect to the Console port of the WS-4232-L3, you can see that the startup process of the module is normal, but stop the response at Enable Interfaces. www.2cto.com record the engine and 4232 software version, and then go to the Cisco website to use the configuration tool to check that the Supervisor version (5.4.2) is not new enough and must be upgraded. check the Flash capacity, download the latest Cat4000-6-2-1.bin version of the engine software, use TFTP to transfer to 4006: copy tftp flash and modify Boot IOS: clear boot system all set boot system flash bootflash: cat4000.6-2-1.bin restart after the normal identification of the WS-X4232-L3. configuring WS-X4232-L3 doesn't look like 5000 RSM or 6000 MSFC, set up the engine up to Interface vlan1. from the engine perspective, 4006 is via internal taxi 2/1-2 (set 4232 mounted in slot 2) two Gigabit ports are connected to InterfaceG3 and G4 of 4232. These ports are not set to Trunk. how should I configure it? WS-X4232-L3 information is not very easy to find, and finally carefully flip a random pile of data, finally find a small Catalyst 4003 and 4006 layer 3 services moduleinstallation and configuration note. the recommended configuration method is as follows: 1. set 4006-2 to Port Channel and set it to Trunk: set port channel 2/1-2 on set trunk 2/1 on dot1q 1-20 note 2/1 (Note: Only s1, s2.s3 only supports 802.1Q Trunk and ISL (funny ). 2. connect to the 4232 module and enter configure session 2 3. add G3 and G4 to Channel-Group: router (config) # interface port-channed 1 router (config )# Interface g3 router (config-if) # channel-group 1 router (config) # interface g4 router (config-if) # channel-group 1 4. configure the route (assuming the corresponding Vlan is configured on 4006): interface port-channel 1.1 encapsulation dot1q 1 (the last parameter is the Vlan ID) ip address xxx. xxx. xxx. xxx. xxx. xxx. xxx repeats this step for each Vlan.