Common Operation steps and related commands for HP UNIX

Activate the lock: vgchange-A y/dev/vglock
Activate the lock Disk: vgchange-a n/dev/vglock
Compile and generate a binary configuration file: # cmapplyconf-v-C/etc/cmcluster. ASC configure the dual-host software package to modify the following main files: scupkg. ASC control. Sh spy. Sh
Synchronize the PKG configuration file on both nodes
Compile and generate PKG: cmapplyconf-v-P/etc/cmcluster/scupkg. ASC to start the dual-host system: perform the following operations on scu_a as the root user: SCU % Su-Root
# Cmruncl-v-F-N scu_a
# Cmviewcl
Confirm that the cluster is started on scu_a and then perform the following operations: # cmrunnode-V scu_ B
# Cmviewcl-vcluster starts to run normally and scu_ B is added to the cluster. The following figure shows the cluster status.
Hpcluster up
Node status
Scu_a up running
Scu_ B up running
Package status state pkg_switch Node
Scupkg up running enabled scu_a if all goes well, the status of each node should be running, and the package status should be up. Common commands for HP dual-Host: 1. cmruncl-F-v-N node_name (for example, scp1) // start cluster2, cmhaltcl-V // stop cluster3, cmrunnode-V node_name // Add the node to cluster4, cmhaltnode-V node_name // The Node exits cluster5, cmrunpkg-V package_name (such as scppkg)) // run the Software Package 6 and cmmodpkg-e-v package_name (the package can be switched) // modify the software package switch flag 7, cmhaltpkg-V package_name // stop the software package 8, cmviewcl-v-P package_name (smppkg) // check the dual-host status 9, cmcheckconf [-V] [-C cluster_ascii_file] [-P pkg_ascii_file] // check the dual-host configuration and package Configuration
10. cmapplyconf [-V] [-C cluster_ascii_file] [-P pkg_ascii_file] // compile and generate a dual-host configuration file, including the configuration file 11 and ,. /spy. sh auto_recover standby)