Computer boot broadband connection slow how to do?

How to solve the problem of slow computer boot broadband connection.

In fact, the reason why the computer boot broadband connection is slow mainly because Windows boot into the desktop after the system will temporarily stagnate for a period of time, then start any program will not respond, this is because the DHCP client service Windows XP is assigning IP addresses for network cards, The system will temporarily stagnate for a period of time, generally this time will not be very long, the general user can accept, but if affected by other factors of the system, broadband connection is relatively slow, which is also a lot of users do not want to see.

So what causes the computer to boot broadband connection slow?

The system Daquan summarizes the following main points:

① computer virus causes the Dial-up connection program to run slowly and so on.

② you are on the Internet line, such as the network line may be aging, routers or asdl cats and other malfunctions

③ boot Startup items too much, causing the boot system startup slow, natural broadband connections are also affected.

④ system broadband connection settings, DHCP Client service when the computer is turned on the network card will be assigned IP address, so the connection is slow, you can use fixed IP address to resolve.

Cause the computer to boot broadband connection is mostly due to the above reasons, to solve the problem of computer broadband connection slow, no doubt should start with the above 4 points.

First, the novice should start from easy, first use anti-virus software for the overall system scan, cleaning up the computer may have impact on the broadband connection of malicious programs and Trojans, after the elimination of viruses we can carry out the computer startup Project optimization.

solves the computer system virus problem as well as the startup project and so on the question, next we may inspect the cat or the router, checks the network cable connection is reliable, the broadband cat's light is normal flashing, the summer strengthens the heat dissipation, when necessary restarts the broadband router.

If conditions permit can also replace the cat and the router to see the effect, the general hardware problems occur is not much.

After the above problem is eliminated, then the last step of the investigation, which is also the most important setting, fixed IP address, so that the DHCP client service does not need to automatically obtain and allocate, in most cases this step setting effect is very obvious, set the method as follows:

⒈ in the case of normal computer connection to the network, first of all, we need to get under the current computer normal access to the IP address, access to the following methods:

Enter Start--run--After you enter CMD in the Open dialog box, click OK, as shown in the following figure:

Start-run-cmd command into DOS control

Click on the OK button in the above image to enter the Windows DOS Command dialog box, as shown in the following figure: