ENSP Configuring static routes, RIP routes, OSPF routes

The network topology diagram is as follows

Divide the network segment well

I'm so divided.
Pc
Here only screenshot PC1 content, PC2,PC3 content according to the design of the network segment to fill out

Note that when you're done, remember to point to the bottom right corner of the app

Router
Static routing Configuration
Port IP

Static route table

Attention

After each PC and R are configured, ping

RIP protocol

After configuration, use the DIS IP routing-table command to view the routing table information.

Try a ping.

Ospf

Left as area 1, right for zone zero, 192IP address as router ID
Configured as follows

The other two routers are configured Similarly, note that the left side only area 1, the right only region 0;
After configuring, view the routing table: DIS IP routing-table will see the following information

I'm pinging the router's IP address here.

Small oranges are just learning this area just, there is nothing wrong also please point out, discuss together.
I also have a question here, why there is no OSPF path in the R6 routing table. If a small partner knows to share.