Firmware upgrade for gk101 arbitrary wave generator released (Version: 1.0.1build803)

I. Firmware description:

Hardware version: 0, logic.3

Firmware Version: 1.0.1.build803

Compilation Date:

==============================================

Ii. Firmware Version description:

1. Added burst and synchronization functions.

==============================================

Three, firmware download link: http://pan.baidu.com/s/1kTA5eIj Password: nuw1 =====================================================4, instructions for use:

If you click the "pulse string" button for the version after upgrade, You need to upgrade the logical firmware. Please contact us

If you enter the following interface, you can use this page function normally.

1. Working Mode

• Edge trigger (rising edge)

When this button is selected, the device works in edge trigger mode. With the trigger type buttons, you can select automatic trigger, External Trigger, manual trigger, and other types.

• External Door Control

According to the output waveform of the trigger input, when the trigger input is high, the waveform is output, and the waveform is not output.

• Manual control

You can manually control the waveform output and shutdown, click the "open" button in ③ to output the waveform, and click the "close" button to close the waveform output.

2. Trigger type

These three buttons are valid only when you click the "edge trigger" button in section 1.

• Automatic trigger

The trigger condition is edge trigger. The trigger period is determined based on the value set in cycle 4 (unit: seconds). The number of waveforms output each time is determined based on the value set in the number 5.

• External Trigger

The trigger condition is edge trigger, and the trigger frequency is determined based on the trigger input signal frequency. The number of waveforms of each trigger output is determined based on the value set by the 5th number.

• Manually triggered

Click "one time" in ③ to trigger a waveform output. The number of waveform outputs is determined based on the value set in ⑤.

3. Manual Control

Only when "manual control" is set in ① working mode, the "open" and "close" buttons are valid.

Only when "edge trigger" is set in the ① working mode and "manual trigger" is set in the ② trigger type. The button "single time" is valid.

4. Periodic settings

Click a number to set the trigger cycle, in seconds. The value range is 1-10.000 S.

5. Set the number

Click a number to set the number of Output Waveforms for triggering. The value range is 1-256.

6. data input button

Click the arrow key to adjust the value.