Acer 4710 white screen Problem

Yesterday morning (February 27), when I got online, the machine suddenly went to the white screen. I couldn't help it, and I couldn't see any operations. Only shutdown-r-t 0 can be used to restart the machine. However, this problem occurs on the BIOS interface after the machine is restarted. Therefore, it is suspected that the display may be suspended due to hardware problems. So we can only temporarily shut down the instance and use shutdown-s-t 0 to shut down the instance. After some time, I found that the screen was restored to normal again. I was delighted, but it wasn't long before, and another problem occurred. During this period, it will not help.

As a result, Google only encountered this problem when the screen was normal and found that this series of machines had this problem, which may be a problem with the mold. The machines of other people soon encountered this problem, and I had just purchased it for two and a half years. It seems Lucky. Here is a post about how to solve the white screen problem. Completely solves the problems of Acer 4710 series white screen, flash screen, and flower screen. I have used this method, but the effect is not significant and it does not work completely. But I can be sure that, as mentioned in this post, it is a problem with screen display. The simple re-plug-in may be another problem to ensure that the plug-in is not useful.

So I boldly adjusted the screen plug-in when I started the system. I found that the screen was normal after slight adjustment, and there was no problem during long running. It seems that it is critical to find this position. However, when preparing to close the protective cover, the screen is still discolored, probably because the lid is pressed to the screen.
Take a look at this figure:

My cable is special. I am referring to the black tape above. This tape is not very regular. I thought it was possible that the lid would overwhelm the tape, leading to problems in line contact. So I2The raised plastic at the place is broken down. Note that this section of plastic should be used to fix the display light on the panel, so be careful. Then carefully split the irregular tape at the cable and cut off some of it. This step should be very careful, cut a line, the display can not be used.

Close the Panel and no problems are found. Although the Panel is a bit broken, you can use it. Minimize the possibility of loose screen. OriginalAsus A8The series also has an notorious pivot issue.

For other methods, it is mentioned that PowerStrip can be installed (for graphics card overclocking), but it does not work after I install it. On YouTube, you can refer to a video about how to solve 4310.