AVAYA Cajun vswitch Initialization Configuration (management address, gateway, Change Password)

AVAYA Cajun vswitch Initialization Configuration (management address, gateway, Change Password) we recommend that you plan the management address, gateway, and VLAN division method before configuring all vswitches. vlan id, the IP network segment of each VLAN, the gateway of the VLAN, the IP addresses of various servers, and other information related to network operation must be planned. Then, the workflow should be planned and what should be done first, this will be of great help to the regulation of future work. In addition, various debugging configuration documents should be prepared at the same time, because this is required during acceptance. For the first time at www.2cto.com, you must prepare for the switch configuration. In addition to an exchange in the packaging box, you must also use a quick installation manual and a data CD, the cables, serial adapters, power cables, and other accessories are packed in a tray. The Accessories include four pads and cable racks attached to the vswitch. The first step is to connect one end of the configuration cable to the "console" Port of the switch, and the other is to connect the serial port adapter to plug the adapter into the serial port of the computer, and then start the "Super Terminal" in the windows operating system ", enter a descriptive name in the displayed "connection description" window "name" as required, select the port connected to the serial adapter in the window after "OK", and press "OK ", in the port Properties window, click "Restore to default" and then click "OK ". At this time, there is no information in the Super Terminal window. Step 2 connect the power cord of the switch, connect the power cord to the outlet with the power off, and then turn on the power of the outlet. Step 3 of www.2cto.com: Observe the super terminal window, and the switch startup information will appear. Normally, "login:" will appear. Enter the built-in user name "root" of the switch and press Enter. "password: "enter" root "and press Enter." Switch Name> "appears. Enter" set interface inband 1 <IP address> <subnet mask> ", <IP address> and <subnet mask> should be replaced with the planned IP address. For example, if you want to set the management address of the vswitch to 192.168.168.10, if the mask is 255.255.255.0, enter "set interface inband 1 192.168.168.10 255.255.255.255.0", and then you will be prompted to use the "reset" command to restart the switch. After you log on again, use "set ip route <destination CIDR Block> <gateway ip address>". For example, if you want to search for all unknown ip addresses through "192.168.168.1, the specific command is "set ip route 0.0.0.0 192.168.168.1 ". Now the vswitch Initialization Configuration is complete.