Cisco simulator static Routing and dynamic routing configuration

Cisco simulator static routing, dynamic routing rip configuration

Dynamic routing protocol RIP commands are simpler than two lines

The experiment topology diagram is as follows:

More Wonderful content: http://www.bianceng.cnhttp://www.bianceng.cn/Network/lyjs/

To implement PC1 and PC2 communication, you need to configure R1, R2,R3

1. The static configuration command format is as follows:

For R1

router>en

Router#conf

Configuring from terminal, memory, or network [terminal]?

Enter configuration commands, one per line. End With cntl/z.

Router (config) #ip Route 192.168.3.0 255.255.255.0 192.168.2.2

IP route + Destination network segment + Destination segment Subnet mask + Next hop IP

View Configuration router#show IP route in privileged mode

Other routes for empathy configuration

2. RIP Dynamic Routing configuration Command Network + adjacent network segment

Router#config

Configuring from terminal, memory, or network [terminal]?

Enter configuration commands, one per line. End With cntl/z.

Router (config) #router rip

Router (config-router) #network 192.168.1.0

Router (config-router) #network 192.168.2.0

Router#write

Building configuration ...

[OK]