I believe many people have encountered unknown pin and failed to add class member when using dxp and AD, after experiments, we found that creating a new PCB can solve these problems. This is also a common practice on the Internet. However, it is time-consuming and effort-consuming to create a PCB by giving up the first half of the layout and wiring. Therefore, I was thinking that since an error was reported, there was definitely a solution, so I studied and found the following solution. Hope to help you.
This prompt is displayed because the current PCB already contains net. You only need to delete all the net on the current Board and then import it. You do not need to worry about it now. Click to continue.
Same as above.
How to solve the unknown pin problem is actually very simple. As mentioned above, you only need to delete all the net on the current PCB. Follow these steps.
After deleting the file, you can import the file again.2Graph start tillUnknown pinThe problem has been solved. No more prompts or redX.
The following describes how to solve the problem.Add component classesError. The prompt is:Failed to add class member:Xxx
See the following figure for solutions.
After deletion, there will be only one all component classes left, and then re-import will find that the problem is solved perfectly. Hope to help you.