HP Computer/HP notebook cannot install Ghost system solution

Method One:

1, press F10 into the CMOS, to find the power settings (Management Setup), the WDRT support set to Disabled;

2, press F10 to save and exit.

Method Two:

1, press F10 into the BIOS settings;

2, with the left and right arrow keys to choose to Advanced (Advanced settings) option;

3, with the upper and lower arrow keys selected to "Onboard Pata/sata adapters" (and port/serial hard disk);

4, select the third "SATA1 Controller mode" serial hard disk control mode, the original serial disk mode of the machine is the IDE, that is, this mode can only install the original operating system, can not install the ghost version of the operating system, click Enter;

5, select "AHCI" mode. This mode only installs the Ghost version of the system, but does not start the machine normally.

6, press F10 to save and exit;

7, reboot after the installation of the Ghost system, installed after the restart, and then press F10 into the BIOS, the hard disk mode can be changed back to the IDE mode.