Photoshop filter produces cool ice cube effect

Finish effect:

1. New file (mode RGB)

2. Use a pen to draw the following shapes, or you can draw a rounded square, through the perspective of the transformation.

3. Fill color, color attention to see the parameters of RGB.

4. Set the inner glow of the graphic, parameters:

5. Select-Modify-shrink command.

6. Feather a bit.

7. Fill Color

8. Merge two layers

9. Copy a layer out

10. Change the hue saturation of the layer above.

11. The taskbar on the left does not need to be tube, select this graphic with a rectangular box, do not cancel the selection.

12. Box selection, not too big (I was afraid of the above steps misleading everyone)

13. Perform filters-Sketch-base Highlights

14. The parameters are as follows

15. The effect is as follows:

16. Execute Filter-Sketch-Luo Juan

17. The effect is as follows: (cancel constituency after completion)

18. Perform filter-twist-wave

19. The parameters are as follows:

20. The effect is as follows:

21. Put the layer below to the top, ctrl+f repeat just the twist filter, so that it matches the shape of the following figure.

22. Then swap the layer, for the previous we do the Luo Huang gradient layer for color adjustment.

23. The effect is as follows:

24. Just do the layer, and then copy a layer out.

25. Perform filter-skew-wave with the following parameters:

26. Once again, the parameters are as follows:

27. The result of the completion is as follows:

28. Import a selection of the following layers

29. Mask the above selection with a selection of the following layer.

30. Change the blending mode of the second layer to "linear light".

31. Merge all layers except figure.

32 that background is very poke, so I made a new one.

33. Put the ice cubes up, start making a reflection, copy an ice, put it under the ice

34. Adjustment order

35 The Reflection layer mask to cover, make it natural.

36. In the same way, make some small ice cubes and put them next to each other.

37, began to make ice cold fog, with a white brush at random to draw some soft edge lines.

37, began to make ice cold fog, with a white brush at random to draw some soft edge lines.

39. Smear using the Smudge tool

40. Use the eraser to erase the spare parts (this step can be arbitrary, almost on the line)

41. After the smear, add some embellishment of the leaves to be completed.

Note : More wonderful tutorials Please pay attention to the triple Photoshop tutorial section, triple PS group: 182958314 welcome you to join

Category:

• PS Filter Tutorial