Rac _ report version too high when installing software, rac report

Rac _ report version too high when installing software, rac report

Original Works are from the blog of "Deep Blue blog". You are welcome to reprint them. Please note the following source when reprinting them. Otherwise, you will be held legally liable for copyright.

Deep Blue blog: http://blog.csdn.net/huangyanlong/article/details/40457129

Environment: CentOS5.6 64bit1_oracle11g11.2.0.4.01_oracle11g11.2.0.1.01_linux.x64_11gr2_grid.zip

An error was reported when installing oracle software during rac setup. Due to version problems, oracle software cannot be installed. The following error is returned:

After checking the text information, the cluster software version is 11.2.0.1.0 and the database version is 11.2.0.4.0. Because the grid has been installed, you can easily download the 11.2.0.1.0 database from the official website.

Re-execute the database installation for version 11.2.0.1.0, and the installation was successful, as shown below:

The next page is displayed, as shown below:

Original Works are from the blog of "Deep Blue blog". You are welcome to reprint them. Please note the following source when reprinting them. Otherwise, you will be held legally liable for copyright.

Deep Blue blog: http://blog.csdn.net/huangyanlong/article/details/40457129 

When Oracle10g_RAC is installed with VMware, racnode1 executes rootsh successfully, but the following error is reported when rootsh is executed on racnode2:

VMware what version are you using?
Failed to start ASM
Failed to start Oracle Clusterware stack
Unable to enable asm
What software have you installed before, and whether the port conflict exists.
We recommend that you first install oracle and then another one. Apache

The expert instructed me to install ORACLE 11g rac and finally executed the rootsh script on the two nodes to report an error solution. I am grateful for the solution.

The cluster is not successfully installed!
The ora. crsd component is not started!

Pay attention to your partition during installation

After reinstalling the backup partition, you must format it again!

Otherwise, the grid component fails to be installed.

Obviously, your cluster fails to be installed.

Run
Tail-500/u01/app/11.2.0/grid/export toollogs/crsconfig/rootcrs_rac1.log

Post information