Router configuration basics-set the dialog process
1. router>
The vro is in the USER command status. You can view the connection status of the vro and access other networks and hosts, but cannot view and change the vro settings.
2. router #
Enter enable at the router> prompt, and the vrouter enters the privileged command status router #. In this case, you can not only execute all user commands, but also view and change the vro settings.
3. router (config )#
Enter configure terminal at the router # prompt, and the prompt router (config) # appears. At this time, the vro is in the global setting state, and you can set the global parameters of the vrouter.
4. router (config-if) #; router (config-line) #; router (config-router )#;...
The vro is in the local setting state. You can set a local parameter of the vro.
5.>
The vro is in the RXBOOT status. Press ctrl-break within 60 seconds after the vro is started to enter this status. In this case, the vro cannot complete normal functions. You can only perform software upgrade and manual boot.
6. Set the dialog status
This status automatically enters when a new vro is started. You can also use the SETUP command in the privileged command status to enter this status. In this case, you can set the vro through dialog.