Frame-Relay configurations for different routers

With the rapid development of network technology and the wide application of Internet, the requirements for communication media are getting higher and higher. Frame-relay) is rapidly popularized with stable communication, fast speed, and favorable price. The key to making good use of Frame relay is the configuration of the router. The following describes the frame relay configurations of several commonly used routers, hoping to serve as an example:

1. CISCO router configuration

Interface Serial0: configure the wide-area Port)

Encapsulation frame-relay IETF encapsulates frame relay)

Frame-relay lm-type ansi

The frame relay protocol is ansi, which corresponds to the Post Office)

Ip address port ip address Subnet Mask

Frame-relay interface-dlci 16

16. The dlci number assigned to the port by the Post Office)

Ip route peer ip address subnet mask peer wide area Port ip Address

2. Frame relay restriction for 3COM vrouters)

Set Privilege = NetMgr authorized Network Management)

Setd-ip cont = route (activate the routing function)

Setd! 3-path linetype = leased line type is leased line)

Setd! 4-port own = framerelay the physical connection type is frame relay)

Setd! 4-fr cont = ansilmi protocol type is ansi)

Setd! 4-ip net = 11.53.240.34

255.255.255.252 port IP address subnet mask)

Add-ip addr peer ip address @ 460 (460 is the peer dlci number)

Add-ip route peer Subnet Mask

Peer Wide Area IP address 1 metric (number of hops)

Setd! 3-path cont = e activation path)

Setd! 4-port cont = e activated port)

3. The frame relay restriction section of the BDCOM router is set)

Co

Select Chinese interface)

Quit

S0

Encap framerelay

Ip add Wide Area Ip subnet mask

Fr local_dlci add 1616 this party's DLCI number)

Map add peer Wide Area IP address pvc 16 (local DLCI)

Quit

Route add peer CIDR Block mask peer wide area Port IP address 1 hop count)

Hosts add 127.0.0.1 localhost

The above is the frame relay configuration of the three commonly used routers. The key points are four: Line encapsulation, protocol, DLCI, and IP address. I hope this article will be helpful to all colleagues who are configuring Frame Relay for routers.

1. Frame-Relay configurations for different routers
2. Interconnection Configuration between ATM and FRAME-RELAY
3. Common configuration commands for Cisco Routers