How does the computer install the system on a solid-state drive?

first, the hard disk mode adjustment:

1, the most important to adjust the hard disk mode for solid-state drives, solid-state drives must be Achi mode, or not be able to complete the performance of solid state, so in the case of solid state, check our hard drive is AHCI mode.

2.

3,

4, according to the above figure to adjust the hard drive mode for AHCI (each motherboard adjustment mode is different, but most of them are similar.) )

Ii. Adjustment of Zoning

1, the adjustment partition has two kinds of division, the GUID partition and the ordinary partition, here first does not speak the GUID partition to skip, because the GUID partition all is the active partition, and does not have above to adjust the place, as long as divides on the line. Of course, incidentally, divide the ESP partition onto a solid-state drive.

2, adjust the ordinary partition a little trouble, the quickest way is a key partition, of course, this refers to we have nothing to save the case! The partition is from the solid state hard disk, the C disk is assigned to the SSD, and will be set to active partition, the other letter all set into logical partition!

Also remember that partitioning is 4K aligned, which is the key to the performance of solid-state drives:

Third, System installation

U disk mounted WIN10 System tutorial

U disk mounted WIN8 System tutorial

U disk mounted win7 System tutorial

Iv. Adjustment of the startup item

1, set the hard disk mode, set the key, since the system has been installed to the solid state hard drive, naturally in order to start faster, it should be the SSD set to the first boot.

2

3, after the completion of the installation can be restarted into the system