How to disassemble the monitor base

The bottom of the LCD is mainly divided into two parts, the base and the shaft, disassembly is also relatively simple, starting from the base, the following is the specific steps:

A. Base Disassembly

First, the LCD flat on the table, note that the table must be flat, and the desktop does not have any sundries, so as not to bump damage to the LCD screen, of course, if the bottom can put some sponge or other flat soft things better.

Graphic

Two. The general display of the base is not used to fix screws, just hold down the monitor base of the buckle, downward force can be, then the monitor's base will be removed, as shown in the following figure.

Base Disassembly diagram

"Note": Different display base design method is also different, not all the monitor base can be down hard. Some may also have fixed screws, before demolition, we must pay attention to observe the structure of their own display base, understand the principle and then disassemble.

B. Shaft Disassembly

After the base is removed, the next thing we need to do is to disassemble the hinge, as follows:

First, remove the buckle cover on the hinge, as shown in the following figure.

Two. Then you can see that the internal axis of the shaft is usually a number of screws fixed, here we need to remove the fixed screws, and then can be very easy to remove the hinge, as shown in the following figure.

Small series with their own computer monitors as an example, detailed introduction of the LCD base disassembly method. Of course, different display base design may be different, but overall, will not be too complicated, we need to do is extrapolate, enhance their hands-on ability and analytical ability.