How to Set a nested wireless router under a vro

Connect the LAN of Route 1 to the WAN of Route 2, and then

Connect the network cable from the LAN port of Route 2 to a computer.
Start Configuration

1. settings on the local machine
1: Open the network neighbor, attribute

2. In the pop-up local Connection Properties window, on the General tab, there is a "this connection uses the following

Project, find and double-click "Internet protocol TCP/IP ". Change the IP address

192.168.1.2. You do not need to fill in the subnet mask. If you click it manually, it will automatically fill in

255.255.255.0. The IP address of your vro1.1, that is, 192.168.1.1. (Of course, this is OK.

It may be a little troublesome. If you want to make it more convenient, you can directly select all IP addresses and DNS addresses as automatic, because

The router is automatically allocated by default ). Then click OK to complete the settings of the local machine.

.

2. vro settings
3. Open IE, enter 192.168.1.1 in the address bar, and press Enter. At this time, the system will prompt you to lose

Enter the user name and password. Then, enter admin as the user name and password to enter the routing management field.

Face

Next, change the LAN address of Route 2 from 192.168.1.1 to 192.168.2.1, and then restart Route 2.
After the restart, you also need to change the local connection address from 192.168.1.2 to 192.168.2.2.
The gateway can be changed from 192.168.1.1 to 192.168.2.1, the LAN address of Route 2, which has just been redefined. You must change it. Otherwise, you will not be able to enter Route 2.

4. The system will automatically prompt you for the Configuration Wizard. Click Next until you see

When you select an Internet connection method, you can choose it based on your actual situation. Because you use dual-route, Route 2 (that is, the wireless one) to use static address allocation, unless Route 1 is configured with DHCP, dynamic IP addresses are supported.
Static configuration?
For example, if your route 1 is not DHCP enabled, but you know that its LAN is 192.168.1.1, then,
In route 2, you can set the static WAN parameter
IP: 192.168.1.200
Subnet: 255.255.255.0
Gateway: 192.168.1.1
DNS: If you know the DNS number of the local network operator, enter the local address. If you do not know, you can also enter route 1 Gateway (192.168.1.1 ), let Route 1 help you automatically jump to the local DNS server.

5. Click Save.
6. Find the DHCP server and enable DHCP. Remember to enable it.
7. Save it again.

8. Configure the LAN parameters of Route 2 on other computers to access the Internet.
For example
IP192.168.2.X
Subnet: 255.255.255.0
Gateway: 192.168.2.1
DNS: If you know the DNS number of the local network operator, enter the local address. If you do not know, you can also enter route 2 Gateway (192.168.2.1 ), let Route 1 help you automatically jump to the local DNS server.
Of course, because I just asked you to enable DHCP in Route 2, you can also enable other computers to automatically do it without manual configuration.